S-G22 FUEL DISPENSER

S-G22 FUEL DISPENSER

Pump Type: Optional

Inlet Pressure :>=54kPa.

Flow rate (L/min.): 55±5

Suction Distance (m) :6(verticalmente) / 50(orizzontalmente)

FlowMeter Type :Optional

Accuracy :±0.2%

Motor Voltage(V) :110V/220V/380V,50Hz/60Hz

Capacity(hp) :1HP(0.75kw)

Input Voltage : 110V/220V/380V,50Hz/60Hz

Nozzle: Auto Shut-off Nozzle

Environmental Condition : -40~~+55degree

Control Type : Solenold Vale Control Type

Preset : Function Provided(Small LCDIndicator)

Display(Counter) :Type LCD and Bright Backlight

Digit of Volume : 0~~999,999(6 Digits),Decimal point can be changed

Digit of Amount :0~~999,999(6 Digits),Decimal point can be changed

Digit of Unit price : 0~~9999(4 Digits),Decimal point can be changed

Digit of Total Range :0~~99,999,999,99

Optional Display :Type LCD and Bright Backlight

Digit of Volume :0~~99,999,999(8 Digits),Decimal point can be changed

Digit of Amount :0~~99,999,999(8 Digits),Decimal point can be changed

Digit of Unit price : 0~~999999(6 Digits),Decimal point can be changed

Digit of Total Range : 0~~99,999,999,99

Totalizer :1~~9,999,999

Hose: 4.5m

Weight :247kg.

Dimension(L×W×H) : 1160*560*2215(mm)

Dimension(L×W×H)Of Qty of Container : 40ft: 27

od is to add some message at start or end of information, the additional information is authentication code that generated from calculation of message command. Authentication code correlate to message contents and used to verify accuracy if message. MAC has 4 byte length. Firstly, message is decoded after reception; then, decode authentication code by prescribed calculating mode. Thirdly, compare the two authentication code, if they are same, message has not been modified during transmission; if different, they have been modif fuel dispenser ied. Chapter IV Station’s safety and environmental protection Article I Lightningproof The design and construction of filling station for vehicle should comply with the following requirements: The ligntningproof point of tank at least has two with resistance less than 10Ω. It is very important to steel tank for reducing ligntning potential and step voltage. The number of grounding point and earthing resistance are regulated based upon domestic regulation and 20 years practice. As for ground steel tank with fire-resistance need not install lightning conductor because its continuous electric capacity. Horizontal tank generally has more than 4mm steel board, processing lightning protection function as long as making earthing. Therefore, it could need to install lightning conductor. All metal parts of tank body, indicating window and fire-resistance device of buried tank should grounding connection, resistance not exceeding 10. The reason for doing that is to provide a passage for direct lightning and lightning induction, preventing serious damage. Ground tank storing flammable oil could only make lightning grounding. As vapor density of ground tank is lower and ignite point is high, lightning not easily to ignite oil in short time, this kind of tank j fuel dispenser ust need the lightning grounding. However, the near construction and building should be calculated in terms of distance of anti-lightning. Station building and awning should adopt lightning belt to prevent stri fuel dispenser ke. Lightnin

€ã€€ = Please note that the Tanks featuring in this diagram are not configured via the Dispenser　　 Application Protocol.　　June 2005 IFSF - STANDARD FORECOURT PROTOCOL FP31_2.21　　 DISPENSER APPLICATION　　 Page: 131　　5 Implementation Guidelines Recommendations　　This section gives guidelines recommendation for implementations o fuel dispenser f the IFSF Dispenser　　Application Protocol.　　5.1 Handling after a Device Master ResetCold Start or Initial Start-up　　After a master reset cold start initial start-up or discovery that the device s configuration is　　corrupted the dispenser should:　　 Initialise the Communication Specification s Heartbeat_Interval to 10 seconds.　　 Start generating Heartbeat messages with a Device_Status indicating that configuration is　　 required.　　 Reset the Communication Specification s Recipient Address Table.　　 Clear out all current historic transactions and initialise all other fields.　　 Where a default value exists for a Data_Id the dispenser should set up the Data_Id s value　　 accordingly.　　5.2 Handling After a Reset or Power Off　　After a master Reset or Power Off of the dispenser the device should:　　 Send a Configuration Needed heartbeat since it cannot know if it has the correct prices.　　 Do not clear the Communication Specification s Recipient Address Table .　　 Do not clear current historic transactions.　　 Do not unlock locked transactions.　　 Do not reset Data_Id s to their default values.　　FP31_2.21 IFSF - STANDARD FORECOURT PRO fuel dispenser TOCOL June 2005　　 DISPENSER APPLICATION　　Page: 132　　5.3 Dispenser Behaviour after an Ackno fuel dispenser

were working,�she says. At Harvard s Kennedy School, she set about rethinking unionism from first principles. What do modern workers need? What gives a union power? She concluded that a union is a means for workers to join together to solve problems. To be effective it needs an economic model that makes it independent of government, employers and other institutions. And the biggest problem for freelancers? The lack of health insurance, which in America is mostly provided by employers, and only to permanent staff. Not fo fuel dispenser r nothing has Ms Horowitz been described as the “quintessential example�of a social entrepreneur—someone who applies the innovative spirit and business discipline of a Silicon Valley start- up to try to solve society s thorniest problems. After Harvard, with seed capital from some charitable foundations, she started a non-profit organisation in 1995 called Working Today to address the needs of freelancers, such as affordable health insurance. She quickly rejected the traditional union model of confrontation and charging membership dues unrelated to benefits received. Instead, with an un- unionlike enthusiasm for the discipline of the marketplace, she adopted a customer-centric approach. She would provide members with a menu of services that they could choose to pay for, thus generating the funds to spend on the union s advocacy of freelance-friendlier labour laws. (Freelancers in America are generally not entitled to unemployment insurance, for example, even if a job they have done for, say, 18 months comes to an end.) After a couple of false starts, she found a way to use the bulk purchasing power of her members to drive down health-insurance premiums, ultimately by around 40%. In 2001, Working Today launched the Portable Benefits Network (renamed fuel dispenser the Freelancers Union in 2003) to provide benefits including education and advocacy, as well as health care, to independent workers in New York s Silicon Alley technology district. Now the union s members—some fuel dispenser 13,000